Enwrapping surfaces with point contact — comparisson between catia method and analitical one

  • Silviu Berbinsci Dunarea de Jos University of Galati, Department of Manufacturing, Robotics and Welding Engineering, Romania
  • Virgil Teodor Dunarea de Jos University of Galati, Department of Manufacturing, Robotics and Welding Engineering, Romania
  • Nicolae Baroiu Dunarea de Jos University of Galati, Department of Manufacturing, Robotics and Welding Engineering, Romania
  • Nicolae Oancea Dunarea de Jos University of Galati, Department of Manufacturing, Robotics and Welding Engineering, Romania
Keywords: worm mill, polygonal shaft, CATIA

Abstract

In this paper, is made the comparison between the profiles of the worm tool, which generates a polygonal shaft, obtained by a classical analytical method and the graphical method developed in the CATIA design environment. The comparison is made in order to determine the quality of the profiling method of tools which generate, by point contact, ordered curls of surfaces. The form of the intermediate surface (the generating rack-gear) and the form of characteristic curves are presented in graphical form, and the form of axial profiles of the worm mill calculated by the two methods is presented in numerical form.

Downloads

Download data is not yet available.
Published
2011-11-16
How to Cite
1.
Berbinsci S, Teodor V, Baroiu N, Oancea N. Enwrapping surfaces with point contact — comparisson between catia method and analitical one. Annals of ”Dunarea de Jos” University of Galati, Fascicle V, Technologies in machine building [Internet]. 16Nov.2011 [cited 29Mar.2024];29(2):117-23. Available from: https://www.gup.ugal.ro/ugaljournals/index.php/tmb/article/view/1788
Section
Articles

Most read articles by the same author(s)