Influence of the tools geometry on the deep-drawing force

Mitică Afteni; Mihaela Banu; Viorel Păunoiu; Ionuț Constantin

Mitică Afteni Dunarea de Jos University of Galati, Department of Manufacturing, Robotics and Welding Engineering, Romania
Mihaela Banu Dunarea de Jos University of Galati, Department of Manufacturing, Robotics and Welding Engineering, Romania
Viorel Păunoiu Dunarea de Jos University of Galati, Department of Manufacturing, Robotics and Welding Engineering, Romania
Ionuț Constantin Dunarea de Jos University of Galati, Department of Manufacturing, Robotics and Welding Engineering, Romania

Keywords: deep-drawing force, punch geometry, punch strokepunch stroke

Abstract

Deep-drawing processes are usually used in automotive industry. In this area the specimen dimensions are between same millimetres in case of small devices to metres in case of a car body. In this study it is presented a comparative analysis about the influence of the punch geometry on the deep-drawing force. Experimental deep-drawing tests were performed. The material used in experiments was steel sheets with 0.5 mm in thickness. In the experiments were used four different dies with different geometries. The influence of the die radius on the deep drawing force
was studied. From the experimental data it was concluded that the punch geometry have the main influence on the deep-drawing force. The small differences seen in the case of using dies with small radius lead to the conclusions that this parameter have no significant influence on the deep-drawing force.

Influence of the tools geometry on the deep-drawing force

Abstract

Most read articles by the same author(s)