Cutting Tool Temperature in Cylindrical Turning

  • Maria Neagu “Dunarea de Jos“ University of Galati
Keywords: cutting tool, turning, tool temperature, wear

Abstract

This paper is presenting a numerical model for tool temperature during cylindrical turning process. A Fourier series approximation is used as a pattern for cutting tool temperature and this model is loaded with constant and variable heat flux input as well as convective cooling conditions. The influence of the temperature dependent material properties is also taken into consideration. The influence of these conditions on the cutting tool maximum temperature position and level is analyzed as a factor for determination of the tool wear.

Published
2006-09-15
How to Cite
1.
Neagu M. Cutting Tool Temperature in Cylindrical Turning. Annals of ”Dunarea de Jos” University of Galati, Fascicle V, Technologies in machine building [Internet]. 15Sep.2006 [cited 25Apr.2024];24:25-0. Available from: https://www.gup.ugal.ro/ugaljournals/index.php/tmb/article/view/2062
Issue
Vol 24 (2006)
Section
Articles

Most read articles by the same author(s)

Obs.: This plugin requires at least one statistics/report plugin to be enabled. If your statistics plugins provide more than one metric then please also select a main metric on the admin's site settings page and/or on the journal manager's settings pages.