White Layer Suppression and Surface Integrity Enhancement in Hard Turning of AISI D3 Steel Using CBN Inserts under Dry and Gas Mixture Cooling

  • S. Girisankar Department of Mechanical Engineering, Vels University, Pallavaram, Tamilnadu, India
  • S. Senthil Murugan Department of Mechanical Engineering, Sri Venkateswara College of Engineering (Autonomous), Tamilnadu, India
  • M. J. I. Raj Department of Mechanical Engineering, Mar Ephraem College of Engineering and Technology, Tamil Nadu, India
  • C. Dhanasekaran Department of Mechanical Engineering, Vels University, Pallavaram, Tamilnadu, India
  • M. Chandrasekaran Department of Mechanical Engineering, Vels University, Pallavaram, Tamilnadu, India
DOI: https://doi.org/10.35219/awet.2025.08
Keywords: CBN, dry machining, gas mixture cooling, hard turning, white layer

Abstract

Superalloys and hardened steels are widely used across industries due to their superior mechanical properties, including high hardness, toughness, wear resistance, and fatigue strength. Because of these characteristics, they typically require grinding for final finishing; however, grinding operations demand expensive machinery, specialized equipment, high-cost abrasive wheels, lengthy setup procedures, and extended machining cycles. As a result, hard turning has emerged as a preferred alternative for finishing hard-to-cut materials, offering advantages such as reduced lead time, lower setup and tooling costs (no fixtures or form wheels), and decreased energy and coolant requirements. In addition, hard turning (HT) can achieve better part quality compared to conventional grinding. However, the process is often affected by the formation of a detrimental surface feature known as the white layer (WL), which significantly reduces fatigue life and undermines surface reliability due to dynamic phase transformations. In this study, super-hardened AISI D3 steel was machined using a semi-worn CBN insert under dry machining and gas-mixture cooling conditions. The results indicate that dry machining neither eliminated the WL nor improved surface finish, whereas gas-mixture cooling effectively suppressed WL formation and produced superior surface quality.

Downloads

Download data is not yet available.
Published
2025-12-15
How to Cite
Issue
Vol 36 (2025)
Section
Articles

Papers accepted for publication become the copyrighted property of the Annals of "Dunarea de Jos" University of Galati, Fascicle XII, Welding Equipment and Technology. No part of the publication may be reproduced or transmitted in any form, or by any means, electronic or mechanical, including photocopy, recording, or any information storage and retrieval system, except in limited quantities for the non-commercial purposes of scientific or educational advancement, without permission in writing from the Editorial Board.