Structure-Property Correlation of Composite Materials Based on Cu-Mo Obtained by PVD Method
Abstract
The paper describes reviews referring to determination of working parameters of the development processes of composites in copper matrix, by vapour-phase deposition method. The molybdenum was used as complementary phase. Structural characterization of coatings developed by optical microscopy and electronic scanning and effects of surface structure on their characteristics were presented. The specificity of the technology for obtaining Cu-Mo composites is a condition to formation a special laminated structure. The mechanical characteristics of the condensate depending on the amount of molibden. An important role in forming the structure and characteristics is played by the defects which were formed in the condensate during the transfer in the liquid phase as drops. Electrochemical tests have shown that the corrosion resistance of the composites obtained by PVD method is higher than pure copper.
References
[2]. S. Constantinescu, O. Mitoşeriu - Microstructural and layers superficial properties by the CVD method, The Annals of “Dunarea de Jos” University of Galati, Fascicle IX. Metallurgy and Materials Science, nr.2/2004, ISSN 1453-083X, p. 51 –55.
[3]. S. Constantinescu, T. Radu - The effect of heat treatment parameters on the structure and properties of the thick plates made from steel X60, The Journal International Metallurgy, nr. 4/2004, p. 28-32.
[4]. S. Constantinescu, L. Orac - Material properties and methods of control, Ed. Europlus, Galati, Romania, ISBN: 973-30-1709-4, (2007).
[5]. V.G. Grechanyuk, V.A. Denisenco, L. Orac - Structurre and corrosive firmness of composition materials on basis of copper and molybdenum electron beam technology metod, The Annals of ‘Dunărea de Jos’ University of Galaţi, Fascicle IX Metallurgy and Material Science,Vol. 1, (2007).
