Problems and Solutions Regarding the Centrifugal Casting of Wire Sheave for Heavy Cranes
Résumé
The centrifugal casting of wire sheave is a technological method that ensures the important quality requirement, the continuity of the material in the active rolling zone of the sheave. However the centrifugal casting has some difficulties: the stability of the casting system, small productivity, gas permeability of the cast mould. The paper shows the problems induced by the centrifugal casting of these parts and the solutions for their solving.
##plugins.generic.usageStats.downloads##
##plugins.generic.usageStats.noStats##
Références
[1]. Gadea, S. a.o. – Manualul inginerului metalurg, vol.2, Editura Tehnica Bucuresti, 1982.
[2]. Zubac, V. – Utilaje pentru turnatorie, Editura didactica si pedagogica, Bucuresti, 1982.
[3]. Stefanescu, C. Indreptar pentru turnatori, Editura tehnica, Bucuresti, 1972.
[4]. Stefanescu, D.M. – Stiinta si ingineria solidificarii pieselor turnate, Editura AGIR, Bucuresti, 2007.
[5]. Fredriksson, H. – Metals Handbook Ninth Edition, vol. 15, Casting, ASM International, Ohio, 1988.
[2]. Zubac, V. – Utilaje pentru turnatorie, Editura didactica si pedagogica, Bucuresti, 1982.
[3]. Stefanescu, C. Indreptar pentru turnatori, Editura tehnica, Bucuresti, 1972.
[4]. Stefanescu, D.M. – Stiinta si ingineria solidificarii pieselor turnate, Editura AGIR, Bucuresti, 2007.
[5]. Fredriksson, H. – Metals Handbook Ninth Edition, vol. 15, Casting, ASM International, Ohio, 1988.
Publiée
2010-03-15
Comment citer
1.
CANANAU N, SCARLAT D, FLOREA G. Problems and Solutions Regarding the Centrifugal Casting of Wire Sheave for Heavy Cranes. The Annals of “Dunarea de Jos” University of Galati. Fascicle IX, Metallurgy and Materials Science [Internet]. 15mars2010 [cité 6août2025];33(1):5-. Available from: https://www.gup.ugal.ro/ugaljournals/index.php/mms/article/view/3012
Numéro
Rubrique
Articles