Researches Concerning the Correlation of the Semiplanetary Rolling Process Factors

  • Nicolae CĂNĂNĂU "Dunarea de Jos" University of Galati, Romania
  • Petrică ALEXANDRU "Dunarea de Jos" University of Galati, Romania
  • Gheorghe GURĂU "Dunarea de Jos" University of Galati, Romania
  • Adriana PREDA "Dunarea de Jos" University of Galati, Romania
Keywords: continuous casting, semiplanetary rolling, unbending process

Abstract

An available solution of the elimination of the superficial cracks network at the continuous cast slabs is the semiplanetary rolling. The application of a semiplanetary rolling mill at the exit of slab from the curve zone of the continuous casting machine leads at the slab unbending. For real constructive conditions of the geometry of casting machine, the establishing of the factors of semiplanetary rolling process, is necessary. The researches showed in this paper, worked at a lab semiplanetary mill, demonstrate that the bending of the linear body or the unbending of the curve body is possible. At the same time is establishing a correlation between the geometrical factors of body and the semiplanetary rolling factor – the relative reduction of thickness.

Creative Commons License

References

[1]. Wiesenfeld, D., 1999, “Thread and form rolling - planetary (rotary) versus flat die machines”, Steel Time Intern., Sept. 1999.
[2]. Anon, 1995, “Thin Hot Strip Using Planetary Mill”, Steel Time Intern., Sept. 1995, 33-35.
[3]. Cănănău, N., Ivănescu, A., 2001, “Study on the Relation between the Quality of Continuous Cast Slabs and the Surface Discontinuities of the Steel Thick Sheet”, ’International Conference on Advances in Materials and Processing Technologies”, September 18-21, Leganes, Madrid, Spain, vol. 2, p. 949-954.
[4]. Cănănău, N., Gurău, G., 2005, “Semi-planetary rolling process and experimental simulation” Buletinul Institutului Politehnic Iasi, tom LI, Fasc. 2, p. 59-65.
[5]. Moussy, F., Franciosi, P., 1990,“Physique et mechanique de la mise en forme des metaux”, Presses de CNRS, IRSID, Paris.
[6]. Gelin, J., Oudin, J., Ravalard, Y., 1984, “Influence de quelques parametres metallurgiques sur la rupture ductile des acieres a bas de moyen carbone”, Mem. Et. Sci. Rev. Metall. 81.
[7]. Cănănău, N., Ivănescu, A., 1999, “Cercetari în vederea optimizarii procesului de turnare continua în scopul eliminarii fisurilor superficiale”. Universitatea din Galati.
[8]. Cănănău, N., “Cercetari privind comportarea sub tensiune a unor oteluri turnate continuu, la temperaturi de 850-1200 oC”, Contract de cercetare, Universitatea din Galaţi, 2002.
Published
2006-05-15
How to Cite
1.
CĂNĂNĂU N, ALEXANDRU P, GURĂU G, PREDA A. Researches Concerning the Correlation of the Semiplanetary Rolling Process Factors. The Annals of “Dunarea de Jos” University of Galati. Fascicle IX, Metallurgy and Materials Science [Internet]. 15May2006 [cited 4May2024];29(1):27-0. Available from: https://www.gup.ugal.ro/ugaljournals/index.php/mms/article/view/3223
Section
Articles

Most read articles by the same author(s)

Obs.: This plugin requires at least one statistics/report plugin to be enabled. If your statistics plugins provide more than one metric then please also select a main metric on the admin's site settings page and/or on the journal manager's settings pages.