Additive Manufacturing Through 3D Printing of the Mark HOS Pipe DN 50, Using ABS+ Filament
Keywords:
Hose pipe, 3D printing, Fused Deposition Modeling, water drilling installation
Abstract
This paper deals with the additive manufacturing by 3D printing of the Hose Pipe DN 50 landmark which is part of the Gas Reduction R2-Hose DN 2 in subassembly. This sub-assembly is a component part of the washing head of the light water well drilling installations FA 100, FA 125, FH 150 and FG 40. The generic name of the washing head will be FA 100. We use 3D printing technology because, on the one hand, it is technically possible to make the part and on the other hand, for economic reasons. It is approximately ten times cheaper to make the part through 3D printing than through conventional technologies.
References
[1]. Fica Sorin Alexandru, Realizarea unei instalații inovative de foraj hidrogeologic cu acționare hidraulică a sistemului de manevră si acționare mecanică a capului de foraj de tip FA125, Programul cercetare NUCLEU, 2017.
[2]. Fica Sorin Alexandru, Additive manufacturing through 3D printing FDM-Fused Deposit Modeling of press bush, Editura Academica Brăncuși, Târgu Jiu, ISSN 1844-640X, Fiability and Durability, no. 1, 2023.
[3]. Fica Sorin Alexandru, Washing Head Housing, 3D printing from FA 100 drilling installation, using PETG fillament, Editura Academica Brăncuși, Târgu Jiu, ISSN 1844-640X, Fiability and Durability, no. 1, 2023.
[4]. Zukas V., Jonas A. Zukas, An Introduction in 3D Printing, First Edition, Design Publishing Inc., 2015.
[5]. France A. K., Make: 3D Printing, the Essential Guide to 3D Printers, Maker Media, 2020.
[6]. J. Wild, Fusion 360 Step by Step, Landau, Germany, 2021.
[2]. Fica Sorin Alexandru, Additive manufacturing through 3D printing FDM-Fused Deposit Modeling of press bush, Editura Academica Brăncuși, Târgu Jiu, ISSN 1844-640X, Fiability and Durability, no. 1, 2023.
[3]. Fica Sorin Alexandru, Washing Head Housing, 3D printing from FA 100 drilling installation, using PETG fillament, Editura Academica Brăncuși, Târgu Jiu, ISSN 1844-640X, Fiability and Durability, no. 1, 2023.
[4]. Zukas V., Jonas A. Zukas, An Introduction in 3D Printing, First Edition, Design Publishing Inc., 2015.
[5]. France A. K., Make: 3D Printing, the Essential Guide to 3D Printers, Maker Media, 2020.
[6]. J. Wild, Fusion 360 Step by Step, Landau, Germany, 2021.
Published
2023-06-15
How to Cite
1.
FICĂ SA, BABIȘ C, DIMITRESCU A. Additive Manufacturing Through 3D Printing of the Mark HOS Pipe DN 50, Using ABS+ Filament. The Annals of “Dunarea de Jos” University of Galati. Fascicle IX, Metallurgy and Materials Science [Internet]. 15Jun.2023 [cited 9May2024];46(2):49-2. Available from: https://www.gup.ugal.ro/ugaljournals/index.php/mms/article/view/6126
Issue
Section
Articles
