3D Modeling of Recycling Equipment by Magnetic Separation of Used Sandblasting Sand

  • Dorin EFTIMIE "Dunarea de Jos" University of Galati, Romania
DOI: https://doi.org/10.35219/mms.2019.3.06
Keywords: recycling used sandblasting sand, 3D modelling of recycling equipment

Abstract

The paper presents the 3D modelling of recycling equipment by magnetic separation of the used sandblasting sand. The modelling was done using the software NX 7.5 from Siemens.
Magnetic separation is performed in three stages, two steps in dry separation and one step in wet separation. The magnetic separation operation is performed with three drums with remnant magnets designed optimized according to the design requirements.
3D modelling of this type of equipment will allow modular design for any parameters required by the design theme.

Creative Commons License

Downloads

Download data is not yet available.

References

[1]. ***, https://www.worksafe.qld.gov.au
[2]. ***, High-End solution CAD/CAM/CAE Siemens NX 8.0.
Fascicle_9_3_2019
Published
2019-09-15
How to Cite
1.
EFTIMIE D. 3D Modeling of Recycling Equipment by Magnetic Separation of Used Sandblasting Sand. The Annals of “Dunarea de Jos” University of Galati. Fascicle IX, Metallurgy and Materials Science [Internet]. 15Sep.2019 [cited 18Jan.2025];42(3):32-5. Available from: https://www.gup.ugal.ro/ugaljournals/index.php/mms/article/view/2803
Issue
Vol 42 No 3 (2019)
Section
Articles